Engineering

This week’s lab is based on the application of Fourier analysis of an inductive circuit in Multisim. You will learn to utilize Multisim to measure the unknown frequencies in the spectrum. 1. Analyze the circuit and determine the output voltage ‘Vout’ of an Op Amp circuit, use a frequency of 150Hz. 2. Construct Figure 18.15 in Multisim and perform the Fourier analysis. a. Run simulation to measure the frequency and the voltage gain of the amplifier. b. Change the input voltage magnitude to the values from the table and run the Fourier analysis again. c. Record the frequencies visible in the frequency spectrum in the table. d. Take the screen capture for the measurements for ‘Vout’.

SAMPLE ASSIGNMENT
Powered by WordPress